Specification:

Temperature controller working without auxiliary energy. Available with immersion sensor or contact sensor. For use with two- and three-way valves. Overheating reliability: 30 K above set value. Higher values are obtained by turning the hand wheel to higher figures. The control range may be limited and locked. Connection thread M 30 x 1.5 Temperature controller with immersion sensor immersion pocket thread 1.2”

       Control range            Capillary length    Item no.

68 – 122°F  (20-150 °C)        6.5’ (2 m)      114 05 61

104 - 158°F (40-170 °C)        6.5’ (2 m)      114 05 62

158 - 212°F (70-100 °C)        6.5’ (2 m)      114 05 63

122 - 176°F (50-180 °C)        6.5’ (2 m)      114 05 64

68 – 122°F  (20-150 °C)        16’ (5 m)       114 05 71

104 - 158°F (40-170 °C)        16’ (5 m)       114 05 72

158 - 212°F (70-100 °C)        16’ (5 m)       114 05 74

Temperature controller with contact sensor

and heat transfer unit

     Control range            Capillary length    Item no.

68 – 122°F  (20-150 °C)        6.5’ (2 m)      114 28 61

104 - 158°F (40-170 °C)        6.5’ (2 m)      114 28 62

86 - 140°F   (30-  60 °C)        6.5’ (2 m)      114 28 63

122 - 176°F (50-180 °C)        6.5’ (2 m)      114 28 64

Application:

Temperature control for industrial installations, boilers,counterflow appliances, air heaters, dish washers, oil preheaters, air driers, water mixers, condensers, underfloor heating systems etc. Other models, e.g. with double sensor or spiral sensor for higher sensitivity on demand. Mode of operation when used with straight and angle pattern radiator valves, 3.8”-11.4”, item no's. 118 .. ..: With the temperature rising at the sensor, the valve is closed and with the temperature falling, the valve is opened. Mode of operation when used with three-way diverting valves ”Tri-D”, item no. 113 .. ..: With the temperature rising at the sensor, the straight port is closed and the angle port is opened and vice versa. The angle port is only closed if the nominal value is set at least 10 K above the lower value of the control range. Mode of operation when used with three-way mixing valves ”Tri-M”, item no. 113 .. ..: With the temperature rising at the sensor, the straight port is opened and the angle port is closed and vice versa. The straight port is only closed if the nominal value is set at least 10 K above the lower value of the control range.